Toshiba Magnia Z500 - Manual (Page 205)

Installing Software
AFT, ALB and IPSec functions
187
(13)In the “Security rules for Communicating with other Comput-
ers” screen, make sure that both the “All IP Traffic” and
“Dynamic” checkboxes are marked, and select “Add”.
(14)When the “Security Rules Used for Communications with
Other Computers” screen is displayed, make sure that the
“Dynamic” checkbox is marked, and that the “Use Add Wiz-
ard” checkbox at the bottom right is marked, and select
“Add”. Then select “Next” in the next screen (“Welcome to
the IP Security Rule Wizard”).
(15)When the “Tunnel Endpoint” screen is displayed, make sure
that the “This rule does not specify a tunnel” checkbox is
marked, and select “Next”.
(16)When the “Network Type” screen is displayed, make sure that
the “All network connections” checkbox is marked, and select
“Next”.
(17)The sequence from here up to step (20) is the “ICMP Traffic”
security setup.
The screen changes to the “Authentication Method” screen. In
the same way as in step (4), mark the “Use this string to pro-
tect the key exchange (preshared key)” checkbox, and set the
same temporary shared key as in (4). When you have set the
temporary shared key, select “Next”.
(18)When the “IP Filter List” screen is displayed, make sure that
the “All ICMP Traffic” checkbox is marked, and select
“Next”.
(19)When the “Filter Action” screen is displayed, mark the “Per-
mit” checkbox, and select “Next”.
The screen changes to the “Completing the New Rule Wiz-
ard” screen. Make sure that the “Edit properties” checkbox is
marked, and select “Done”.
(20)When the “New Rule Properties” screen is displayed, make
sure that the “All ICMP Traffic” checkbox is marked, and
select “OK”.
(21)In the “Security rules for communicating with other comput-
ers” screen, make sure that the “All IP Traffic”, “All ICMP