Toshiba Magnia Z500 - Manual (Page 56)

Getting Started
Setup of system configuration
37
Setup of system configuration
If the system is used as it was configured at the factory, it was
properly set up before shipment. However, if something optional
is added to the system after shipment, or it is desired to change the
operating condition properly for use, it is required to set up the sys-
tem once again.
There are the following utilities prepared for setup of the system
configuration.
See “System Configuration Setup” on page 150.
NOTE: When the system configuration has been changed,
make a note of the configuration information.
BIOS setup utility
This utility software is designed to manage (set, store, etc.) the
hardware resources of the server, for example: memory addresses,
I/O ports, DMA channels, and interrupt levels.
Setup of the time
The time on this server can be set by the BIOS setup utility or the
OS you are using.
The RTC has a certain error, and the error is increased cumula-
tively if it is remained.
To avoid the harmful influence for the operation, adjust the clock
periodically.
SCSI utility
The SCSI utility is to be used to set the SCSI controller of the
SCSI riser card (optional).