beautypg.com

2) scsi connector (), Installing scsi device, Terminator – Toshiba Magnia Z500 User Manual

Page 153: Scsi id, Changing the scsi id, 2 disconnect the ac power cable, 2) scsi connector, Terminator scsi id

background image

External Unit Setup

Installing SCSI device

134

(2) SCSI connector (

)

Used to connect the System Unit.

See “How to connect peripheral devices” on page 27.

Installing SCSI device

The installation of a SCSI device requires special knowledge or
technique. If you have no experience in installing a SCSI device
or if the job seems difficult, consult your authorized MAGNIA
service provider.

Terminator

The SCSI bus is terminated at the SCSI controller and dedicated
External Device Bay Unit Z1. Set the terminator of the installed
SCSI device to disabled.

SCSI ID

The SCSI ID of the SCSI device to be installed is set so that it does
not overlap with the SCSI ID of other devices installed.
The SCSI ID of the previously installed device is “5”.

When installing the second External Device Bay Unit Z1, change
the SCSI ID in the procedure below.

Changing the SCSI ID

Changing the SCSI ID in the procedure described below, while
see “Before starting operation” on page 54:

1 If the server is running, shut it down and turn off the power.

NOTE: Installing the SCSI device while the power is on may
damage the server and SCSI device.

2 Disconnect the AC power cable.