Toshiba Magnia Z500 - Manual (Page 177)

System Configuration Setup
SCSI Utility
158
Send Start Unit Command
Specifies whether a start unit command is to be sent from
the SCSI controller to start the SCSI device.
BIOS Multiple LUN Support
Specifies whether logical unit numbers are supported.
Include in BIOS Scan
Specifies whether the device is to be scanned when SCSI
BIOS starts.
! Advanced Configuration
Sets up detailed data on the SCSI controller.
The following submenu appears:
Reset SCSI Bus at IC Initialization
Specifies whether or not to reset the SCSI bus during the
SCSI controller resetting process.
Display Message
During BIOS Initialization
Sets data to be displayed in the SCSI Utility startup mes-
sage.
Extended Int13 Translation for
DOS Drive > 1GByte
Specifies whether extended BIOS is to be enabled or dis-
abled for a DOS drive with a disk capacity exceeding 1GB.
Reset SCSI Bus at IC Initialization: [Enabled]
Display Message
During BIOS Initialization: [Enabled]
Extended Int13 Translation for
DOS Drive > 1GByte: [Enabled]
POST Display Mode: [Verbose]
SCSI Controller Int13 Support: [Enabled]
Support Removable Disks Under
Int13 as Fixed Disks: [Disabled]