Toshiba Magnia Z500 - Manual (Page 215)

Troubleshooting
Troubleshooting
198
5 Disconnect backup devices (e.g. Tape Drive) if any connected
to the SCSI controller before installing the OS.
The OS does not boot, or the OS bootup stops midway
A probable cause is various factors ranging from the hardware
connection state up to the installed OS status. Carry out the follow-
ing procedure to check the cause of the trouble.
If this does not remedy the problem, see “Remedy When Win-
dows 2000 is Unusable” on page 201.
See “Installing/removing an optional device” on page 58.
See “Installing software” on page 48.
See the operating manual of the expansion card.
See the operating manual of the peripheral devices.
1 Are all cables firmly and properly connected?
Check only the cables within the scope described in this man-
ual, and instruction manuals for expansion cards and periph-
eral devices.
2 Is a floppy disk inserted in the floppy disk drive?
3 Are the jumper switches and other switches set properly on
expansion cards and peripheral devices?
4 Are expansion cards and Hard Disk Drive (HDD) properly
connected?
5 Is the Hard Disk Drive (HDD) properly formatted and set up if
added?
6 Is the correct version of each device driver installed?
7 Is the server selected if the switch box is used on a Rack Type?
Windows 2000 is locked or cannot be used
Check the previous items to see if those items apply. If an item
applies, carry out the remedy for that item. If none of the items
apply, reboot the server. If Windows 2000 can be used after reboo-