1 remove the front panel, 2 confirm the position of a faulty device, 3 start the megaraid configuration console (mcc) – Toshiba Magnia Z500 User Manual

Page 120: Pulling the detachable lever toward you

Text mode
Original mode

Installing and Removing Hardware

Hard Disk Drive (HDD) –IDE HDD–

101

1 Remove the front panel.

2 Confirm the position of a faulty device.

The STS indicator of the faulty device is lit amber.

CAUTION: The hard disk drive generates heat when in use.
To avoid burns, hold the disk tray when removing the hard
disk drive.

3 Start the MegaRAID Configuration Console (MCC).

4 Tilt over the detachable lever of the slot which holds a defec-

tive hard disk drive, by pulling its knob toward you.

Pulling the detachable lever toward you

NOTE: Before pulling out the hard disk drive, make sure that
it is faulty. If a normally operating device is pulled out by mis-
take, it may damage the server or destroy and lose important
programs or data.