AT&T System 25 User Manual
Page 357
APPENDIX E: Administration Codes and Data
Table E-V. System Administration (Menu=4) (Contd)
ACTION
DESCRIPTlON
DATA
75
Change administration password (up to 8 ["8 characters or less”]
printable characters, no spaces allowed,
display always shows “?????????”)
76
Change display ID for “PDC 0“ (up to 11
[“ATTENDANT’]
printable ASCII characters
77
Change/remove
display ID
for ["11 characters or less,”
unassigned DID numbers (up to 11
or ** to remove;
printable ASCII characters
“OUTSIDE”]
78
Change/remove
display ID
for ["11 characters or less,”
unassigned DID numbers (up to 11 or ** to remove; “NO
printable ASCII characters)
DID,IN”]
81
Switched Loop Attendant system; Audible
[1=Y/0=N]
tone at expiration of hold timer?
83
Switched Loop Attendant system: Length
[1 O-255; 20]
of hold timer (seconds)
84
switched Loop Attendant system: DID
[PD.]
access code to receive “0” treatment (PD.
format, no leading zeros, can’t exist in
system number plan prior to this)
85
Switched Loop Attendant system; Enable
[ 1 = Y / 0 = N ]
automatic hold feature?
86
Switched Loop attendant system: Should
[ 1 = Y / 0 = N ]
calls return to the common queue after
second hold timer expires?
87
Single-position Switched Loop Attendant
[ P D . ]
system: PD. of multiline station serving
as coverage when the attendant is in
POS BUSY mode (PD./station must
already exist)
88
For Switched Loop Attendant System
[1=1st Att.,
ONLY: Specify SLAC attendant (1st or
2=2nd Att.]
2nd) for Action 89, below.
E-38
November 1995