AT&T System 25 - Manual (Page 275)

MAINTENANCE
NOTES :
1. (a) System defaults to a DTAC when first powered up.
(b) You have to remove the DTAC before you can administer the
SLAC .
(c) System 25 can support 1 or 2 DTAC or 1 or 2 SLAC but not a
combination of both.
2. ID names can be assigned for PDCs, Trunks, FPDCs, and DGC groups.
(a)
(b)
(c)
(d)
3. You
Under Menu = 1 or 2 (Port/PDC)
Action = 90 Assign/Remove IDs 11 characters
Under Menu = 1 (Port-Trunk Administration)
Action = 90 Assign/Remove Trunk IDs 11 characters
Under Menu = 5 (FPDC)
Action = 5 Assign/Remove FPDC IDs 11 characters
Under Menu = 6 (DGC)
Action = 14 Assign/Remove DGC
Access Code IDs 11 characters
(Only 9 characters are displayed).
either have automatic hold or automatic release. If automatic
hold is set, you do not have automatic release.
4. (a) Back-up recommended to be an ATL set.
(b) Cannot remove back-up station until POS-Busy button is removed
from SLAC.
(c) Back-up station will be removed automatically when second SLAC
is administered.
Figure 4-13. Clearing Switched Loop Attendant Console Troubles (Sheet
5 of 5)
4-98