AT&T System 25 - Manual (Page 342)

APPENDIX E: Administration Codes and Data
Table E-K. PORT/PDC Administration, Data Terminals (Menu=12)
ACTION DESCRIPTlON DATA
0 Physical port number C S S P P
1 Enter data type code [See Table E-K]
2 Enter D D C [1 -9999; 600-704]
3 Restrict dial access to CO trunk pool† [1=Y/0=N]
4 Restrict dial access to all other trunk [1=Y/0=N]
pools†
12 DDC of station to hunt to next [PDC; 0 for none]
13 Restrict this station from making [1=Y/0=N]
o u t w a r d c a l l s †
14 Assign toll restriction class† [1-4; 0 for none]
15 Assign ARS Facility Restriction Level† [0-3; 3]
21 Enter associated voice/data endpoint [PDC/DDC or
s t a t i o n * 0 for none]
22 Restrict Third-Party Call Set-Up so user [1=Y/0=N]
c a n o n l y establish calls for the
associated station (see Action 21)†
61 Auto-adjust baud rate on c a l l [1=Y/0=N]
origination.* (The default is 0 for
STARLAN CP.)
62 Allow terminal to operate at low bits [1=Y/0=N]
per second (bps)*
63 Allow terminal to operate at a baud rate [1=Y/0=N]
of 300 bps*
64 Allow terminal to operate at a baud rate [1=Y/0=N]
of 1200 bps*
65 Allow terminal to operate at a baud rate [1=Y/0=N]
of 2400 bps*
66 Allow terminal to operate at a baud rate [1=Y/0=N]
of 4800 bps* I
† If data port type code 1802 (STARLAN CP), default values are relevant for the first installed port
on the board. Values assigned to this action item on any of the four ports will be copied to all
four ports on this board.
‡ Not administrable for STARLAN CP.
● Read-only for STARLAN CP.
E-23