AT&T System 25 - Manual (Page 101)

INSTALLATION
4. Complete the Voice and Data Station Records Form (Figure 2-26).
Make SIP Connections to Cabinet for ATL Cordless Telephones
Follow the same procedure as for 7300H Series terminals to connect ATL
Cordless Telephone SIP appearances to the appropriate CPs as outlined
below:
●
Connect the 25-pair connector to a ZTN79 CP
●
Attach a cable label to the octopus cable 25-pair connector and
flag-type tie wrap
● Run the cable to the
● Plug cable ends into
50A Fanning Strip
the appropriate SIP adapters
●
Complete the Voice and Data Station Records Form.
Perform SIP Housekeeping
Before continuing, make the SIP wiring neat:
1.
2.
3.
4.
5.
Make sure that the cables connecting the SIP to building wiring run
neatly through the rings at the top of the SIP. Check that all building
wiring cables connected to an adapter are run through the two
adjoining purse-lock clips and that the clips are twisted closed.
Bundle and tie by circuit type all octopus cable ends not connected
to the SIP. Place unused octopus ends for each cable in a plastic
bag and tie the bagged ends to one of the cables connected to the
SIP.
Make sure that octopus cables hang between the two cable
management posts at the bottom of each column of adapters.
Check that the octopus cables are properly dressed through the
fanning strips (Figure 2-31 ) and that the cables hang neatly between
the fanning strip and 617A Panels. Do not bundle and tie wrap
octopus cables between the fanning strip and SIP unless they are
unused.
Check that all octopus cables are run through the D-rings between
the fanning strips and the cabinet.
2-76