AT&T System 25 - Manual (Page 218)

MAINTENANCE
ERROR MESSAGE
AND DESCRIPTION
POSSIBLE SOLUTION
Port CP Missing B u t Check CP slot; reseat CP; change
“Administered: (Other t h a n CP; or remove C P f r o m
CPU/Memory) Translated port CP translations. If CP does not pass
that CPU cannot access. power-up, replace CP.
Port CP Out Of Service: (Other If the CP has not been removed
than CPU/Memory) Message and the problem persists, check
occurs when a CP is removed or replace the port CP.
from a cabinet. Error removed
when the CP passes power-up.
Port CP ROM Checksum Failure: Try reseating the CP. If this error
The port CP has found that the happens again, then replace the
checksum on its firmware is bad. C P .
Port Buffer Full: (STARLAN If the reset is not successful,
Interface CP) This error resets the reseat CP. If the reseat fails,
C P . replace the CP.
Port Fault: For an auxiliary trunk, C h e c k wiring of external
this message is logged when a equipment (see Figure 4-7).
ground is expected from external
equipment and is not detected.
Port Queue Full: (STARLAN If the reset is not successful,
Interface CP) This error resets the reseat CP. If the reseat fails,
C P . replace the CP.
Program L o g i c Inconsistent: Reseat CP. If problem persists,
( O t h e r t h a n CPU/Memory) replace it.
Possible hardware problem on
port CP.
RAM Test Failed: CPU/Memory Check CPU/Memory CP.
CP has failed the RAM test.
4-42