Table e-m, Port administration, trunks (menu=1), E-26 – AT&T System 25 User Manual
Page 345
APPENDIX E: Administration Codes and Data
Table E-M.
Port Administration, Trunks (Menu=1)
ACTION
DESCRIPTION
DATA
0
Physical port number
CSSPP
1
Enter trunk port type code
2
Enter trunk number
[0001 -9999;
0001-0104]
3
Assign class-of-service code
[(DID–1-4; 3)
(All other—
4
Assign pooled facility access code.
[Facility access code;
(100,101,102)
O if trunk not in
any group]
5
Allow dial access
[l=Y/0=N]
6
Assign the trunk to a DGC group
[1-32; 0 or none]
7
Make this a directed night service trunk
[1 Y/0=N]
8
Assign night service delay announcement
[1 for first
announcement,
2 for second
announcement,
O for none]
9
Type of signaling on incoming calls
[1=Tone/0=Pulse]
(Tie-Trunks only)
10
Determine pooled trunk hunting order of a
specified trunk {Read Only}
11
For Switched Loop Attendant systems ONLY:
[0-7; 0=won’t ring
Priority of trunk to ring in queue†
in queue/or
1=highest priority,
thru 7=lowest
priority]
Note: The TN747B CO Trunk port can be administered as either Ioop-start or ground-
start, but not both at the same time. If a TN747B is administered before it is installed in
a slot, the System 25 must be warm started before it will recognize the TN747B.
†
Not administrable for trunk port type codes 901-902 or 1003-1008.
*
Not administrable for trunk port type codes 901-902 or 1001-1008.
E-26