Allied Telesis AT-S47 - Manual (Page 92)

92
Chapter 11
Basic Multiplexer Commands
This chapter contains the following commands:
Command Function Page
SET IP
Sets the multiplexer’s IP address,
subnet mask and gateway address. 94
SHOW IP Displays the multiplexer’s IP
address, subnet mask and gateway
address. 96
ENABLE BOOTP Enables BOOTP. 97
DISABLE BOOTP Disables BOOTP. 98
SHOW CONFIG Displays the multiplexer’s
configuration. 99
SET SYSTEM
Sets the multiplexer’s name,
location, and contact. 100
SHOW SYSTEM Displays the multiplexer’s name,
location, and contact. 101
SET SNMP COMMUNITY-
STRING Sets the Get, Set, and Trap
community strings. 102
SET SNMP TRAP Sets which traps the management
workstations are to receive. 103
SHOW SNMP Displays the community strings and
the IP addresses of management
workstations to receive traps. 105
PING Instructs the multiplexer to ping a
network node. 106