Allied Telesis AT-S47 - Manual (Page 85)

AT-S47 Management Software User’s Guide
85
AT-S47 Interface
Security
Commands
SET PASSWORD
set password
Assigns a new password to the AT-S47 management interface. The
default is no password.
SHOW CONSOLE
show console
Displays a variety of multiplexer’s console information.
ENABLE CONSOLE
enable console [echo]
Activates the RS232 port on the AT-WDM02 Management Module so
that the multiplexer can be managed locally. Also sets the duplex mode
on the RS232 port to full-duplex.
DISABLE CONSOLE
disable console [echo]
Deactivates the RS232 port on the AT-WDM02 Management Module so
that the multiplexer cannot be managed locally. Also sets the duplex
mode on the RS232 port to half-duplex.
SET CONSOLE
set console [timeout=seconds]
[speed=2400|4800|9600|19200]
Sets the baud rate and the duplex mode (echo) of the RS232 port.
ENABLE TELNET
enable telnet
Activates the Telnet management feature of the AT-WDM02
Management Module so that the multiplexer can be managed remotely
using the Telnet application protocol.
DISABLE TELNET
disable telnet
Deactivates the Telnet management feature of the AT-WDM02
Management Module so that the multiplexer cannot be managed
remotely using the Telnet application protocol.