Allied Telesis AT-S47 - Manual (Page 115)

AT-S47 Management Software User’s Guide
115
SHOW MODULE
Syntax
show module=module|all
Parameter
module Specifies the number of the port or module in the
multiplexer whose status you want to view. The
module numbers are shown in the table below:
You can display the status of more than one port
or module at a time. You can specify the modules
individually (e.g., 2,3,5), as a range (e.g., 7-9), or
both (e.g., 2,5,7-9). To view the status of all
modules, use ALL.
Description
This command is used to display status information about the various
ports and modules in the multiplexer. For definitions on the status
information, refer to Table 2, Module Operating Status on page 45.
Example
The following command displays status information on GBIC ports 4 and
7:
show module=4,7
The following command displays status information on the standard
power supply that ships with the multiplexer:
show module=12
Number Port or Module
1 to 8 GBIC ports 1 to 8
9 WEST multiplexing port
10 EAST multiplexing port
11 Management Module
12 Power Supply A
13 Power Supply B (optional)
14 Fan A
15 Fan B