Allied Telesis AT-S47 - Manual (Page 134)

Section III: Command Line Interface
134
ENABLE CONSOLE
Syntax
enable console [echo]
Parameters
None.
Description
This command activates local management on the multiplexer. When
the console is activated, you can manage the multiplexer using a
terminal or a PC with a terminal emulator connected to the RS232 port
on the management module. The default for local management is
enabled.
You can also use this command to set the duplex mode to full-duplex
(echo) on the RS232 console port of the management module. To set the
console port to half-duplex, refer to the DISABLE CONSOLE command.
Example
The following command enables the RS232 port on the management
module so that the multiplexer can be managed locally:
enable console
The following command configures the RS232 port for full-duplex
(echo):
enable console echo