Allied Telesis AT-S47 - Manual (Page 104)

Section III: Command Line Interface
104
Description
You can use this command to control which multiplexer traps are sent to
the management workstations. The default is for all traps to be sent to all
specified management workstations. For instructions on how to specify
the IP address of a management workstation to receive multiplexer
traps, refer to the SET IP command on page 94.
Example
The following command specifies that only management station 2 is to
receive the fan trap:
set snmp fan=2
The following command specifies that only management stations 1 and
4 are to receive the linktest trap:
set snmp linktest=1,4
The following command specifies that no management workstations are
to receive the moduleinout trap:
set snmp moduleinout=0
fan Transmitted whenever a failure occurs in the
fan module.
overtemperature Transmitted whenever the operating
temperature of the multiplexer exceeds
50
° C and/or the operating temperature of
AT-WDM02 Management Module exceeds
63
° C.
Trap Description