beautypg.com

Resetting the management module, Figure 12: reset wdm02 menu – Allied Telesis AT-S47 User Manual

Page 34

background image

Section II: Menu Interface

34

Resetting the Management Module

There are two ways to reset the management software:

❑ Pressing the RESET switch located on the front panel of the

management module.

❑ Using the Reset and restart the WDM02 feature in the management

software interface.

Resetting the management module does not interrupt the flow of the
Ethernet traffic through the multiplexing ports or GBIC modules.

Note
You cannot reset the multiplexer from the management software.
To reset the multiplexer, you must power OFF and power ON the
unit.

To reset the management module using the AT-S47 Management
Software interface, perform the following procedure:

1. From the Main Menu, select Administration.

2. From the Administration Menu, select Reset and restart the WDM02.

A prompt is displayed asking you to confirm the selection as
shown in Figure 12.

Figure 12 Reset WDM02 Menu

3. Select Yes to reset the management software or No to cancel the

command. The reset process takes only a few seconds.

Do reset WDM02 now? (Yes or No):

Yes

> No

Return to Administration Menu ...