Allied Telesis AT-S47 - Manual (Page 22)

Section I: Getting Started
22
Quitting a
Telnet
Management
Session
To end a Telnet management session, return to the Main Menu and type
Quit. If you are using the command line interface, type quit.
Note
The management software supports only one management session
at a time. Consequently, It is important to always quit a
management session when are finished managing a multiplexer.
Otherwise, you might block future management sessions or
software downloads. You can configure a timeout value so that the
management module automatically disconnects a management
session after a period of inactivity. For instructions on how to
configure a timeout value, refer to Specifying a Timeout Value on
page 68.