Configuring additional file system options – HP StoreAll Storage User Manual
Page 23
7.
Use the Default File Shares dialog box to create an NFS export and/or an SMB share at the
root of the file system. The default settings are used. See
and
for more information.
8.
Review the Summary to ensure that the file system is configured properly. If necessary, you
can return to a dialog box and make any corrections.
Configuring additional file system options
The New Filesystem wizard creates the file system with the default settings for several options. You
can change these settings on the Modify Filesystem Properties dialog box, and can also configure
data retention, data tiering, and file allocation. To open the dialog box, select the file system on
the Filesystems panel. Select Summary from the lower Navigator, and then click Modify on the
Summary panel.
The General tab allows you to enable or disable Export Control and 32-bit compatibility mode on
the file system.
When Export Control is enabled on a file system, by default, StoreAll clients have no access to the
file system. Instead, the system administrator grants the clients access by executing the
ibrix_mount
command. Enabling Export Control does not affect file-system access by file serving
nodes or any NFS/SMB clients attached to the nodes. File serving nodes always have RW access.
By default, file systems are created in 64-bit mode. If clients need to run a 32-bit application, you
can enable 32-bit compatibility mode. This option is applied to the file system at mount time and
can be enabled or disabled as necessary.
Creating a file system
23