HP P6000 Continuous Access Software - Manual (Page 73)

Considerations
•
You can use the GUI, jobs, or the CLUI. See DR groups Actions cross reference .
•
Guidelines apply. See Remote replication guidelines .
•
To resume remote replication in a DR group pair, you must specify the source DR group. See
DR group pair .
Procedure
This procedure uses the GUI.
1. In the navigation pane, select DR Groups.
2. On the List tab, select the source group of the DR group pair in which to resume remote
replication.
3. Select Actions > Resume.
4. Click OK.
Reverting a DR group pair to home
Revert a DR group pair to its home configuration. See DR groups Home .
Considerations
•
You can use the GUI, jobs, or the CLUI. See DR groups Actions cross reference .
•
Guidelines apply. See Remote replication guidelines .
•
To revert a DR group pair to its home configuration, you must specify the destination DR group.
See
DR group pair .
•
You cannot revert to home if the DR group pair is suspended. See DR groups Suspension state .
•
If the DR group pair is already in its home configuration, reverting to home has no impact.
•
If the DR group pair is not already in its home configuration, reverting to home causes a
failover. See DR groups
Failover .
IMPORTANT: Failing over a DR group pair impacts host I/O. Ensure that you understand
the potential impacts of performing a failover. For more information on failover, see the HP
P6000 Continuous Access Implementation Guide.
Procedure
This procedure uses the GUI.
1. In the navigation pane, select DR Groups.
2. On the List tab, select the destination group in the DR group pair to revert to home configuration.
3. Select Actions > Revert to Home.
4. Click OK.
Suspending a DR group pair
Suspend remote replication in a DR group pair. See DR groups Suspension state .
Working with DR groups 73