HP P6000 Continuous Access Software - Manual (Page 32)

This can happen when the document's File Download window opens behind the replication manager
window. This only occurs when running the replication manager in an application mode on the
management server desktop.
To make the document's File Download window visible, select it from the Taskbar or minimize the
replication manager window.
Enabling failsafe on unavailable member in a managed set fails
Problem
Attempting to enable failsafe on unavailable member for a managed set of DR groups fails. The
replication manager logs the message:
Not available:: ERROR: failsafe() not available in current state
Explanation / resolution
This can occur when the managed set in a GUI action or CLUI command contains one or more DR
groups whose remote replication I/O mode is set to asynchronous. Enabling the failsafe on
unavailable member results in an invalid DR group configuration and the action fails.
See also Invalid DR group pair configuration .
Illegal characters
In some cases the following characters are not valid in entries.
Valid in Description Character
Comments Virtual disk
names
Resource names
no no no equal to symbol =
no no no ampersand &
ok no no asterisk *
ok no no colon :
ok no no comma ,
ok no no greater than symbol >
no no no less than symbol <
no no no percent sign %
no no no plus sign +
no no no question mark ?
no no no quotes (double) "
ok no no slash, backward (virgule, solidus) \
no no no slash, forward (virgule, solidus) /
ok no no vertical bar |
Other
~ no ~ Spaces at the end of a virtual disk name
ok no ok Two or more consecutive spaces
Invalid DR group pair—Source and source
Problem
Both groups in a suspended DR group pair are identified as the source group.
32 HP P6000 Replication Solutions Manager