HP P6000 Continuous Access Software - Manual (Page 101)

1. In the navigation pane, select Enabled Hosts.
2. On the List tab, select the enabled host on which you want to run the command, batch file,
or script.
3. Select Actions > Execute Script.
The Execute Console Command window opens.
4. Enter the full path to the command, batch file, or script you want to run. You can also enter
parameters for a command/script.
5. Click OK.
Low-level refreshing enabled hosts
Perform a low-level refresh of specific enabled hosts. See enabled hosts Low-level refresh .
Considerations
•
You can use the GUI or CLUI. See Enabled host actions cross reference .
Procedure
This procedure uses the GUI.
1. In the navigation pane, select Enabled Hosts.
2. On the List tab, select the specific enabled hosts whose properties are to be updated.
3. Click Low-Level Refresh.
The Confirmation Action window opens.
4. To continue, click OK.
The enabled host properties are updated.
Low-level refreshing VM servers
Perform a low-level refresh of specific VM servers. See VM servers low-level refresh .
Considerations
•
You can use the GUI or CLUI. See VM server actions cross reference .
Procedure
This procedure uses the GUI.
1. In the navigation pane, select Enabled Hosts.
2. On the VM Servers tab, select the specific VM servers whose properties are to be updated.
3. Click Low-Level Refresh.
The Confirmation Action window opens.
4. To continue, click OK.
The VM server properties are updated.
Removing enabled hosts from a managed set
Remove enabled hosts from a managed set.
Considerations
•
You can use the GUI or the CLUI. See Enabled host actions cross reference.
Procedure
This procedure uses the GUI.
Working with enabled hosts 101