HP Network Storage Router m2402 - Manual (Page 210)

Controller LUN Commands
216 Network Storage Router M2402 User Guide
Copy Manager Commands
To access Copy Manager or other general management features, the commands
must be sent to the router controller LUNs.
The following controller LUN commands can be used for Copy Manager on the
router:
■ Extended Copy
■ Receive Copy Results
■ Mode Sense (6) and Mode Sense (10)
Each of these commands is discussed in the following paragraphs.
Extended Copy Command
The router supports Extended Copy commands in the following two formats:
■ Version 99-143r1
■ Version SPC-2
To initiate Extended Copy operations, the commands can be sent to any tape
device LUN attached to the router. Multiple concurrent
Extended Copy
commands can be active.
Version 99-143r1
The Extended Copy command supports the following Target descriptor codes
listed in T10 document 99-143r1 (Page 3, Table 10):
The Extended Copy command supports the following Initiator descriptor
codes listed in T10 document 99-143r1 (Page 3, Table 10):
Table 12: Extended Copy Target descriptor codes, version 99-143r1
Item Value
Fibre Channel World Wide Name Target
Descriptor
0xE0
Fibre Channel N_Port Target descriptor 0xE1