HP Network Storage Router m2402 - Manual (Page 114)

Serial/Telnet User Interface
120 Network Storage Router M2402 User Guide
Serial UI Access
To open a serial session, a terminal emulator utility is required.
From most Windows 9x, Windows NT, and Windows 2000 systems, a
HyperTerminal session can be started using the following steps:
1. From the Windows Start menu, open the HyperTerminal window.
2. Name the new terminal session.
3. Indicate the appropriate COM port.
Options include COM1 and COM2.
4. Configure the serial port settings, as listed in the “Installation” chapter.
Note: HP recommends setting the baud rate to 115200.
5. After completing the serial port configuration, select OK to start a serial
session.
6. After the serial session has started, press Enter several times to initiate router
communication and display the Configuration Menu.
Power up Messages
When power is applied to the router, a series of messages is displayed on the serial
terminal or terminal emulation program.
Note: Through out this chapter, XX represents value fields.