HP Network Storage Router m2402 - Manual (Page 177)

FTP User Interface
183 Network Storage Router M2402 User Guide
Restoring the Router Configuration
To restore a configuration to the router:
1. Connect the router to the Ethernet network used by the host computer.
2. Start an FTP session using the router IP address:
ftp <IP address>
where IP address is the address of the router.
The default IP address of the router is 1.1.1.1.
3. Enter the user name and password.
The default user name is root and the default password is password .
HP recommends that the user name and password be changed from the default
values.
4. Specify binary mode:
bin
5. Specify the configuration’s path and filename (with the filename
extension.cfg) using the put command:
put filename.cfg>
The file is transferred to the router. After the file transfer is complete, router will
automatically reboot. When the router completes the POST process, it will use the
restored configuration.
Note: When restoring a configuration, World Wide Name (WWN) values and
Ethernet physical address (MAC address) values revert to the factory default settings.
User defined values for these settings are not retained and must be re-entered after the
restoration of the configuration is complete.
Note: Confirm the restored configuration by verifying that the settings are correct.