HP Network Storage Router m2402 - Manual (Page 176)

FTP User Interface
182 Network Storage Router M2402 User Guide
Backing Up and Restoring Configuration Settings
The router supports the backup and restore of configuration settings over FTP.
This allows multiple configuration files to be maintained in a location external to
the router. When backing up a configuration, the settings are saved from the flash
memory on the router to a binary file in an external location determined by the
user.
Backing up the Router Configuration
To backup the router configuration settings:
1. Connect the router to the Ethernet network used by the host computer.
2. Start an FTP session using the router IP address:
ftp <IP address>
where IP address is the IP address of the router.
The default router IP address is 1.1.1.1.
Note: You will need to specify the external directory location where your FTP utility is
to store the backup configuration file.
3. Enter the user name and password.
The default user name is root and the default password is password .
HP recommends that the user name and password be changed from the default
values.
4. Specify binary mode:
bin
5. Specify the filename (with the extension .cfg) using the get command:
get filename.cfg
The file will transfer to the user specified location.
Note: When backing up a configuration file, the World Wide Name (WWN) values
and Ethernet physical address (MAC address) values are not saved in the
configuration file. All other configuration settings are saved.