HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 53)

Command line 53
Item Description
[TargetPort=] [TargetIP2=
Target IP>] [TargetPort2=]
[Authentication=] [Username=]
[Secret=] [MutualUsername=]
[MutualSecret=]
[iSCSIBootParamDHCP=]
[NetworkParamDHCP=]
[DHCPVendorID=]
Parameter
ConnectionID
(required)
The ID of an existing iSCSI connection. The ID format is . To
retrieve the port number of the iSCSI connection, use the show profile
command.
Options
maskSecret (optional) Enables you to interactively specify the CHAP secret password as a masked
string at the command prompt.
maskMutualSecret
(optional)
Enables you to interactively specify the mutual CHAP secret password as a
masked string at the prompt.
Properties
BootOrder (optional) Enables or disables iSCSI boot. Values for enabling iSCSI boot include
"Primary", "Secondary", or "USE-BIOS". The default value is "Disabled".
LUN (optional) The LUN of the target, which identifies the volume to be accessed. Values for
standard LUNs are 0 to 255 decimal values. Values for extended LUNs are 13-
to 16-character hexadecimal values. The default value is 0.
InitiatorName
(required if
ISCSIBootParamDHCP is
"Disabled")
The name used for the iSCSI initiator on the booting system. The initiator name
length can be a maximum of 223 characters. If the initiator name string contains
non-alphanumeric characters, it must be enclosed in quotation marks.
InitiatorIP (required
if Network ParamDHCP is
"Disabled")
The IP address used by the iSCSI initiator. This value is in dotted decimal format.
Mask (required if
NetworkParamDHCP is
"Disabled")
The IP network mask used by the iSCSI initiator. This value is in dotted decimal
format.
Gateway (optional) The default IP route used by the iSCSI initiator. This value is in dotted decimal
format.
VlanID (optional) The VLAN number that the iSCSI initiator uses for all sent and received packets.
Values range from 1 to 4094.
TargetName (required if
ISCSIBootParamDHCP is
"Disabled")
The name of the target from which to boot. The target name length is a maximum
of 223 characters. If the name string contains non-alphanumeric characters, it
must be enclosed in quotation marks.
TargetIP (required if
ISCSIBootParamDHCP is
"Disabled")
The primary IP address of the iSCSI target.
TargetPort (optional) The TCP port associated with the primary target IP address. The default value is
3260.
TargetIP2 (optional) The alternate target IP address to use if the primary target IP is unavailable.