HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 132)

Command line 132
Item Description
Tests the TACACS+ configuration changes without applying them
->set tacacs Enabled=true ServerAddress=192.168.0.124
ServerKey=test123 SecondaryServerAddress=tacserver.hp.com
SecondaryServerKey=test456
->set tacacs Enabled=true ServerAddress=2001::70
ServerKey=test123 SecondaryServerAddress=tacserver.hp.com
SecondaryServerKey=test456
Enables TACACS+ authentication for users
->set tacacs LoggingEnabled=true
Enables TACACS server logging
Item Description
show tacacs Display the Virtual Connect TACACS+ authentication settings.
Syntax
show tacacs
Example
->show tacacs
Displays TACACS+ information
uplinkport
Manage interconnect module uplink ports.
Supported actions: add, help, remove, set, show
Item Description
add uplinkport Add a new uplink port to an existing network or a shared uplink port set.
Syntax
add uplinkport [Network= |
UplinkSet=]
[Speed=]
[Role=]
Parameter
PortID (required) The ID of an uplink port to add. The ID is a combination of the enclosure name,
interconnect bay, and port number in a single descriptor. The port ID for a network or
an uplinkset that does not contain an FCoE network uses the format
::X.
For QSFP+ ports, the format is Q..
If the uplinkset contains an FCoE network, then the port is configured for all enclosures.
The port name is in the format :X.
Properties
Network
(required)
The name of an existing network to which the port is added if the shared uplink set
name is not specified
UplinkSet
(required)
The name of an existing shared uplink set to which the port is added if the network
name is not specified
Speed (optional) Specifies the port speed for the port (optional). Depending on the VC module, valid
values are "Auto", "10Mb", "100Mb", "1Gb", "10Gb", "40Gb", and "Disabled".
If not specified, the default port speed is "Auto". If no connector is present on the uplink
port, only "Auto" and "Disabled" can be configured as the speed. Speed restrictions
apply.
Role (optional) The role played by the port if the connection mode of the network or shared uplink set
is selected as "Failover". Valid values are "Primary" and "Secondary". The default
value is "Primary". If the uplink set contains an FCoE network, then the Role property is