HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 29)

Command line 29
Item Description
Values include "Enabled" and "Disabled."
Ipv6 Address
(optional)
A valid IPv6 address to use for the domain IPv6 address configuration. The IPv6
address must be specified with a prefix, for example, 2001::3/64.
Ipv6Gateway
(Required if an IPv6
address is
specified)
A valid IPv6 gateway for the domain IPv6 address configuration, for example,
2001::10.
MacType (optional) The type of MAC address source to use for assignment. Values include
"VC-Defined", "Factory-Default", and "User-Defined".
MacPool (optional) The pre-defined MAC pool to use for address assignment. Values include integers
from 1 to 64. This property is valid only if the MacType is set to "VC-Defined". If not
specified, the default pool ID is 1.
Carefully choose the pool so there are no conflicts with other addresses in the
environment.
MacStart (Required
if MacType is
User-Defined)
The starting MAC address in a custom user-defined range. This property is valid
only if the MacType is set to "User-Defined".
MacEnd (Required if
MacType is
User-Defined)
The ending MAC address in a custom user-defined range. This property is valid
only if the MacType is set to "User-Defined".
WwnType(optional) The type of WWN address source to use for assignment. Values include
"VC-Defined", "User-Defined", and "Factory-Default".
WwnPool(optional) The pre-defined WWN pool to use for address assignment. Values include integers
from 1 to 64. This property is valid only if the WwnType is set to "VC-Defined". If
not specified, the default pool ID is 1.
Carefully choose the pool so there are no conflicts with other addresses in the
environment.
WwnStart (Required
if WwnType is
User-Defined)
The starting WWN address in a custom user-defined range. This property is valid
only if the WwnType is set to "User-Defined".
WwnEnd (Required if
WwnType is
User-Defined)
The ending WWN address in a custom user-defined range. This property is valid
only if the WwnType is set to "User-Defined".
SingleDense
(optional)
If the imported domain supports double-dense server blades, this property enables
the device bay display format to support the display for single-dense servers along
with the double-dense servers. In a double-dense supported configuration, the
default for this property is false, which disables the display of single-dense servers.
Examples
->set domain Name=MyNewDomainName
Changes the name of the VC domain
->set domain DomainIp=Enabled
Enables the domain IP address
->set domain DomainIp=Enabled IpAddress=192.168.0.120
SubnetMask=255.255.255.0 Gateway=192.168.0.1
Configures and enables the domain IP address
->set domain DomainIp=Disabled
Disables the domain IP address and uses DHCP instead
->set domain DomainIpv6=Enabled Ipv6Address=2001::34/64
Ipv6Gateway=2002::10
Configures and enables the domain IPv6 address
->set domain DomainIpv6=Disabled
Disables the domain IPv6 address and uses DHCP instead