HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 106)

Command line 106
Item Description
server). The default timeout is 120 seconds.
Examples
->reboot server 2
Reboots the server in device bay 2 of the local enclosure
->reboot server enc0:2 -Force
Forces the server in device bay 2 of the local enclosure to reboot
->reboot server * -ForceOnTimeout -Timeout=180
Attempts a graceful shutdown, but forces a reboot on all servers after a timeout of 2
minutes
->reboot server *
Reboots all servers in the domain
->reboot server enc0:*
Reboots all servers in the local enclosure
->reboot server enc0:1
Reboots the multi-blade server in bays 1-4 of the local enclosure
Item Description
show server Display all servers in the domain.
Syntax
show server
Parameter
ServerID (optional) The ID of a server in the domain. The format of the server ID is
. If the EnclosureID is not specified, the local enclosure is
used by default. For a multi-blade server, the ServerID must be that of the monarch
bay. This is the ID shown in the summary listing.
Examples
->show server
Displays a summary of all servers
->show server *
Displays detailed information for all servers
->show server enc1:*
Displays detailed information for all servers in a remote enclosure
->show server enc0:4
Displays detailed information for the server in device bay 4 of the local enclosure
->show server enc0:5
Displays detailed information for the multi-blade server in bays 5-8 of the local
enclosure
serverid
Manage virtual server ID configuration settings.
Supported actions: help, set, show
Item Description
set serverid Modify virtual server ID domain settings. The serial number attributes can be
changed only in one of the following scenarios:
• The virtual server ID source type is "Factory-Default".
• The virtual server ID source type is "VC-Defined" or "User-Defined", but no
profiles are using server IDs from this source.
• The virtual server ID source type is "User-Defined", and the range is being
extended by lowering the start value or increasing the end value.