HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 23)

Command line 23
cli
This command modifies command execution behavior in script mode and auto-deployment. Script mode is
the same as non-interactive mode.
IMPORTANT: The show config output contains the set cli command with the default
property and value, which is commented out. To modify command execution behavior while
passing a script to CLI over SSH, uncomment and change the value of the ExitOnFailure property.
If this command is specified in an auto-deployment command script, the expected value should be
'true'. If 'false' is specified, it results in a command failure and prevents deployment execution
because overriding command failures is not supported in auto-deployment.
Supported actions: help, set
Item Description
set cli Set CLI command execution behavior. Only supported in script mode.
Syntax
set cli ExitOnFailure=
Property
ExitOnFailure
(required)
Controls whether the VCMCLI will exit on command failure during execution of
commands. This capability is only supported if passing a command script to the
VCMCLI over SSH. If set to false, a failed command displays the appropriate
error message. The script continues and the remaining commands are executed.
Valid values include 'true' and 'false'. The default value is 'true'.
Examples
->set cli ExitOnFailure=False
Sets the CLI to ignore command failure and continue to execute the remaining
commands in the script
->set cli ExitOnFailure=True
Sets the CLI to exit on command failure if a command fails in a script while
passing to the CLI over SSH
config
Display all CLI commands for all objects defined in the domain. The show config command is useful for
generating a CLI script that can be used for creating a domain configuration. The generated script is only
valid for the firmware version currently running. A script generated on one version of firmware is unlikely to
be properly executed by a different version of firmware.
Externally-defined MAC addresses, WWNs and serial numbers are displayed with a warning in the output
and cannot be used on VCMCLI commands when recreating the domain.
Supported actions: help, show
Item Description
show config Generate a configuration script from the running domain.
Syntax
show config -includePoolInfo
Option
includePoolInfo Include VC-defined or user-defined pool assigned SerialNumber, MAC, and
WWN addresses for the domain.
Examples