HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 134)

Command line 134
Item Description
Removes a specific uplink port (Bay 2, Port 3) from a shared uplink set
->remove uplinkport 1:X1 UplinkSet=MyUplinkSet
Removes a specific uplink port (Bay 1, Port 1) from a shared uplink set that contains an
FCoE network (affects all modules within a bay group)
->remove uplinkport enc0:1:Q1.1 Network=MyNetwork
Removes a specific QSFP+ uplink port (Bay 1, Port Q1.1) from a network named
MyNetwork
Item Description
set uplinkport Modify an uplink port that exists as a member of a network or shared uplink port set.
Syntax
set uplinkport [Network=|
UplinkSet=][Speed=
Gb|Disabled>] [Role=]
Parameter
PortID (required) The ID of the port to modify The specified port must already be added to a network or
shared uplink set. The port name for a network or an uplinkset that does not contain an
FCoE network uses the format
::X.
For QSFP+ ports, the format is Q..
If the uplinkset contains an FCoE network, then the port is configured for all enclosures.
The port name is in the format :X.
Properties
Network
(required)
The name of the network to which the port belongs if the shared uplink set name is not
specified
UplinkSet
(required)
The name of the shared uplink set to which the port belongs if the network name is not
specified
Speed (optional) Specifies the port speed for the port. Depending on the VC module, valid values are
"Auto", "10Mb", "100Mb", "1Gb", "10Gb", "40Gb", and "Disabled".
If no connector is present on the uplink port, only "Auto" and "Disabled" can be
configured as the speed. Speed restrictions apply.
Role (optional) The role played by the port if the connection mode of the network or shared uplink set
is selected as "Failover". Valid values are "Primary" and "Secondary". The default
value is "Primary". If the uplink set contains an FCoE network, then the role property is
not allowed.
Examples
->set uplinkport enc0:1:2 Network=MyNetwork Speed=1Gb
Changes the port speed of a network port
->set uplinkport enc0:2:1 Network=MyNetwork Speed=Disabled
Disables a specific port that belongs to a network
->set uplinkport enc0:2:4 UplinkSet=MyUplinkSet Speed=Disabled
Disables a specific port that belongs to a shared uplink set
->set uplinkport enc0:2:4 Network=MyNetwork Role=Secondary
Modifies the role of the network uplink port with the connection mode on the network or
the shared uplink set as "Failover" to take the Secondary port role
->set uplinkport enc0:1:Q1.1 Network=MyNetwork Speed=Auto
Changes the port speed of a QSFP+ uplink port
->set uplinkport enc0:1:Q1.1 Uplinkset=MyUplinkSet Speed=Auto
Changes the port speed of a QSFP+ uplink port that belongs to a shared uplink set
->set uplinkport enc0:1:Q1.1 Network=MyNetwork Speed=40Gb
Changes the port speed of a QSFP+ uplink port to "40Gb"