HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 13)

Introduction 13
Press the Tab key to auto complete subcommands and managed-elements. You can also type characters and
then press the Tab key to see a narrowed-down list of command options.
You can quit the shell by using the exit command. See the example of logging in to the interactive
management shell below. In the example, the primary VCM is located at IP address 192.168.0.120.
>ssh 192.168.0.120
login as: michael
password: ***********
--------------------------------------------------------------------
HP Virtual Connect Management CLI v4.20
(C) Copyright 2006-2014 Hewlett-Packard Development Company, L.P.
All Rights Reserved
--------------------------------------------------------------------
GETTING STARTED:
help : displays a list of available subcommands
exit : quits the command shell
? : displays a list of managed elements for a subcommand
? : displays detailed help for a command
->
Script Mode
In some cases, you might want to write automated scripts that execute a single command at a time. These
scripts can be used to batch several commands in a single script file from the SSH client. See the example of
how to use the script mode for CLI command execution below. In the example, the primary VCM is located
at IP address 192.168.0.120.
->ssh [email protected] show enclosure
IMPORTANT: To suppress prompting for a password during login, you must first setup the SSH
encryption keys using the VCM Web GUI, and configure your SSH client properly with the keys.
For more information on configuring the SSH keys, see the HP Virtual Connect for c-Class
BladeSystem User Guide on the HP website (
http://www.hp.com/go/vc/manuals ).
Remote access to the Virtual Connect Manager
To access the VCM CLI remotely through any SSH session:
1. Using any SSH client application, start an SSH session to the Virtual Connect Manager.
2. When prompted, enter the assigned IP address or DNS name of the Virtual Connect Manager.
3. Enter a valid user name.
4. Enter a valid password. The CLI command prompt appears.
5. Enter commands for the Virtual Connect Manager.
6. To terminate the remote access SSH session, close the communication software or enter exit at the CLI
command prompt.
To access the VCM CLI remotely through the Onboard Administrator CLI, run the connect interconnect
command from the Onboard Administrator CLI.