HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 112)

Command line 112
Item Description
:[:].
The ID for the poll port can be referenced from the output of the show
sflow-ports command.
PollingIntervals
(optional)
Specifies the polling interval which is the maximum number of seconds between
successive samples of the counters associated with these ports. Each value in the
list of polling interval has a corresponding port in the PollPorts list. The valid
polling interval range is from 1 to 65535 seconds. The default value is "10
seconds". Disable polling on a port using the remove sflow-ports
command.
Configure the module network using the set sflow-module command before
adding the module port for sampling or polling to a receiver.
Examples
->set sflow-ports Alpha SamplePorts=enc0:1:d1
Samplingrates=2048 Direction=Both PollPorts=enc0:1:d4
PollingIntervals=10
Modifies sample and polling ports
Item Description
show sflow-ports Display the port to be sampled or polled for a receiver.
Syntax
show sflow-ports []
Parameter
ReceiverName
(optional)
The name of an existing sflow receiver in the domain. A receiver name of "*"'
displays ports of all the receivers.
Examples
->show sflow-ports
Displays the sflow sample and polling ports
->show sflow-ports Alpha
Displays the Alpha sflow port
sflow-receiver
Configure the receivers.
Supported actions: add, help, remove, set, show
Item Description
add sflow-receiver Add a receiver.
Syntax
add sflow-receiver
IpAddress=[Port= <1-65535>]
[MaxHeaderSize=<128|256|512|1024>]
[MaxDatagramSize=<256-1500>]
Parameter
ReceiverName
(required)
Specifies the unique name of the receiver. A valid receiver name can have a
minimum of one character and maximum of 64 characters. Only alphanumeric
characters, -(hyphen), and _(underscore) are allowed. White spaces are not
allowed.
Properties
IpAddress (required) Specifies the IP Address of the receiver where the sflow datagrams are sent
Port (optional) Specifies the UDP port number of the receiver where the sflow datagrams are
sent. The valid range is from 1 to 65535. The default value is "6343".