KROHNE OPTIMASS with MFC 300 EN - Manual (Page 112)

112
Ref Display Description & Settings
C 3.x.13 Simulation For sequence, see Test Level Menu, Fct. B 1
In the following descriptions of the outputs/inputs, "x“ denotes the terminals:
C 3.2 = A / C 3.3 = B / C 3.4 = C / C 3.5 = D (control input connected only to terminals A and B)
C 3.x Status output X
C 3.x.1 Mode
• error in device
• application error
• out of specification.
• polarity, flow
• overrange, flow
• counter 1 preset
• counter 2 preset
• counter 3 preset
• output W
• output Y
• output Z
• off
C 3.x.2
"Output or input"
Dependent on selection
under Fct. 3.x.1, see
above
Appears only when "output W, Y or Z“ activated in Fct. C 2.x.1 Mode,
see above
• same signal (only when
there are 2 status outputs)
Selection dependent on input or output
combination
• polarity
• over range
• Range change (appears
only if set to current output
X in Fct. C 3.x.1, see status
output above)
• off
C 3.x.3 Invert signal
Off Active output generates high current at output, switch closed
On Active output generates low current at output, switch open
C 3.x.4 Information Displays: Serial No, Software No & calibration date of the circuit board
C 3.x.5 Simulation For sequence, see Test Level Menu, Fct. B 1
C 3.x Limit switch X
C 3.x.1 Measurement
• Volume flow rate • Mass flow rate • Temperature
• Density • Diagnosis1 • Diagnosis 2
• Flow Speed • Concentration 1 • Concentration 2
• Concentration Flow1 • Concentration Flow 2 • Diagnosis 3
C 3.x.2 Threshold
xxx.x ± x.xxx (set limit value, hysteresis) format, unit acc. to meas.
range selected and its upper range value. 2nd value (= hysteresis)
F
1st value
C 3.x.3 Polarity
• both polarities Plus and minus values are used
• positive polarity Negative values are set to 0%
• negative polarity Positive values are set to 0%
• absolute Absolute value is used
Choice of meas. value polarity, note flow direction, see C 1.5.1
C 3.x.4 Time constant xx.x s (setting range 000.0…100.0 s)
C 3.x.5 Invert signal
• off Active output generates high current at output, switch closed
• on Active output generates low current at output, switch open
C 3.x.6 Information Displays: Serial No, Software No & calibration date of the circuit board
C 3.x.7 Simulation For sequence, see Test Level Menu, Fct. B 1