KROHNE OPTIMASS with MFC 300 EN - Manual (Page 107)

107
Ref Display Description & Settings
C1.4 System Control Ctd...
C1.4.3
Sys Ctrl
Max Limit
Defines the maximum value for the process control condition
C1.4.4
Sys Ctrl
Min Limit
Defines the minimum value for the process control condition
C1.5 Self Test
C1.5..1 Maximum Temp. Displays the maximum recorded sensor temperature
C1.5.2 Minimum Temp. Displays the minimum recorded sensor temperature
C1.5.3 2 Phase Threshold
Defines acceptable level of 2 phase signal.
Set to zero to disable function.
C1.5.4 Diagnosis Value 1 Defines the parameter for the first diagnosis value. Select from:
• Off (forced to zero) • Sensor Ave (Sensor amplitude)
• Sensor Stdev • Energy level • Tube Frequency
• Strain MT • Strain IC • 2 phase signal
C1.5.5 Diagnosis Value 2
C1.5.6 Diagnosis Value 3
C1.6 Information
C1.6.2 V No Sensor Displays the V-code (identification) of the sensor
C1.6.3 SE Serial No
Displays information of the SE C1.6.4 SE Version
C1.6.5 SE Interface
C1.7 Factory Calibration
C1.7.1 Sensor Type Displays the Sensor Type
C1.7.2 Transducer Size Displays the nominal sensor size
C1.7.3 Transducer Material Displays the sensor material type
C1.7.4 Sensor Maximum Temp Displays the maximum allowable temperature for the sensor
C1.7.5 Sensor Minimum Temp Displays the minimum allowable temperature for the sensor
C1.7.6 CF1
Displays the sensor calibration coefficients (not Cf9 or Cf10)
C1.7.7 CF2
C1.7.8 CF3
C1.7.9 CF4
C1.7.10 CF5
C1.7.11 CF6
C1.7.12 CF7
C1.7.13 CF8
C1.7.14 CF11
C1.7.15 CF12
C1.7.16 CF13
C1.7.17 CF14
C1.7.18 CF15