KROHNE OPTIMASS with MFC 300 EN - Manual (Page 108)

108
Ref Display Description & Settings
C1.7 Factory Calibration ctd...
C1.7.19 CF16
Displays the sensor calibration coefficients (not Cf9 or Cf10)
C1.7.20 CF17
C1.7.21 CF18
C1.7.22 CF19
C1.7.23 CF20
C1.7.24 CF21
C1.7.25 CF22
C1.7.26 CF23
C1.7.27 CF24
C1.7.28 CF25
C1.7.29 CF26
C1.7.30 CF27
C1.8 Simulation
C1.8.1 Mass Flow As B1.1
C1.8.2 Density As B1.2
C1.8.3 Temperature As B1.3
C2 Concentration Refer to Concentration Handbook
C3 I/O
C3.1 Hardware
C3.1.1 Terminals A
Assignment of terminals A - D dependent on MFC 300 version:
Outputs: • current • frequency • pulse • status • limit value
Input: • control
• off (input and/or output switched off)
C3.1.2 Terminals B
C3.1.3 Terminals C
C3.1.4 Terminals D
In the following descriptions of the current output, "x“ denotes the terminals:
C 3.2 = A
C 3.3 = B C 3.4 = C
C 3.x Current output X
C 3.x.1 Range 0% … 100%
xx.x … xx.x mA (setting range 0.00 mA
a
value
a
20.0 mA)
0 mA
a
1st value
a
2nd value
a
20 mA
C 3.x.2 Extended range
xx.x … xx.x mA (setting range 3.5 mA
a
value
a
21.5 mA)
0 mA
a
1st value
a
2nd value
a
21.5 mA
C 3.x.3 Error current
xx.x mA (setting range 0.00 mA
a
value
a
22.0 mA)
0 mA
a
value
a
25 mA (outside the overrange)
C 3.x.4 Error condition
• Application error • Error in device • Out of specification
Condition for fault current: fault in the selected and in
higher fault categories, see Sect. 10.5
C 3.x.5 Measurement
• Volume flow rate • Mass flow rate • Temperature
• Density • Diagnosis1 • Diagnosis 2
• Flow Speed • Concentration 1 • Concentration 2
• Concentration Flow1 • Concentration Flow 2 • Diagnosis 3