KROHNE OPTIMASS with MFC 300 EN - Manual (Page 101)

101
10.2 Time-Out Function
Operator Control Mode
After 5 minutes without key op., return to meas. mode, without acceptance of prev. changed
data.
Test Menu Mode
After 60 minutes without key op., return to meas. mode without acceptance of prev. changed
data.
GDC IR-Interface Mode
After the IR-Interface has been activated in Fct. 6.6.6, the interface must be correctly posi-
tioned and affixed with the suction cups on the pane of the housing within 60 seconds.
Key Meass Mode Menu Mode Function Mode Data Mode
Alternate between
display measured
value pages 1 + 2
and status list(s), if
provided
Select menu
Select function or
(sub) function
Blue cursor:
• change number
• change unit
• change property
• change decimal point
>
Switch from meas-
uring mode to
menu mode. Press
key for 2.5 s to dis-
play the “Quick-
Start“ menu.
Entry into selected
menu displayed,
then 1st function of
menu displayed Entry into dis-
played, selected
function or sub-
function
For numerical values,
move cursor (blue) one
place to the right
g
Return to measur-
ing mode, preceded
by query whether
changed data to be
accepted
Press 1 - 3 times,
to accept data and
return to menu
mode.
Accept data and return
to function or subfunc-
tion.
Esc
(
>
)
Discard data and
return to menu
Discard data and
Return to function or
subfunction.
1
Mounting: GDC IR - Interface
Optical IR-Interface for PC-supported
communication with the signal convert-
er; adapter for the optical interface
option:
See Section 10.4, Fct. 6.6.6.
Please note: The operating point of the 4 optical keys is located directly behind the glass pane.
The most reliable way is to actuate the keys from the front. Actuation from the side of the dis-
play can lead to incorrect operation.
1
LED