KROHNE OPTIMASS with MFC 300 EN - Manual (Page 104)

104
A Quick Setup
Ref Display Description & Settings
A1 Language Description as for C 6.2.1
A2 Tag Description as for C 6.1.1
A3 Reset
A3.1 Reset Errors Description as for C 6.6.1
A3.2 Totaliser 1 Description as for C 4.1.6
A3.3 Totaliser 2 Description as for C 4.2.6
A3.4 Totaliser 3 (where fitted) Description as for C 4.3.6
A4 Analogue Outputs
A4.1 Measurement
Measurement Value used for driving HART
current outputs
A4.2 Unit
Units for measurement value defined in
A4.1
A4.3 Range Range of the output used for A4.1
A4.4 Low Flow Cut-Off
Low Flow Cutoff used for main current out-
put
A4.5 Time Constant Time constant used for main current output
A4 Station Address If Profibus/FF Device – Address of the device at the DP/PA/FF interface
A5 Digital Outputs A5.1 Measurement
Measurement Value used for driving pulse
output D
A5.2 Pulse Value Unit Unit for the Pulse Output D
A5.3 Value per Pulse Value of unit per pulse
A5.4 Low Flow Cut-Off Low Flow Cutoff used for Pulse Output D
A6 GDC IR Interface GDC IR InterfaceDescription as for C 6.6.6,
A7 Zero Calibration Zero Calibration, description as for C.1.1.1
A8 Operation Mode
Input of the instrument state.
Choose from:
Measure
Stop
Stanby
10.4 Table of Settable Functions
For your guidance, all menus and functions in the following tables are marked with letters and
numbers.