GW Instek LCR-8000G Series User Manual
Page 58
REMOTE CONTROL
115
115
115
115
:meas:speed
:meas:speed?
Selects or returns measurement speed.
Send parameter: max, fast, med, slow
Return parameter: 0 (max), 1 (fast), 2 (med), 3
(slow)
:meas:test:ac
Selects AC measurement.
:meas:test:rdc
Selects Rdc measurement.
:meas:test?
Returns measurement type.
Parameter: 0 (AC measurement), 1 (Rdc
measurement)
:meas:trig
Triggers an AC or Rdc measurement manually.
Returns the 1
st
and 2
nd
measurement (only the 1
st
in
Rdc).
Example: –396.283E-6, 99.558 (uF/D)
:mode?
Query the currently selected operating mode.
:rep
:rep?
Enables or returns repetitive measurements when
unit is returned to local control.
Send parameter: on (repetitive), off (single shot)
Return parameter: 0 (single shot), 1 (repetitive)
Example: :rep on (repetitive mode)
:trig
Triggers a measurement in the current mode.
Multi-step program command
:multi:set
Switches to the multi-step set-up page.
:multi:del
Removes a step in the program.
Parameter: 1 ~ 30
Example: :multi:del 2 (deletes step 2)
LCR-8000G Series User Manual
116
116
116
116
:multi:delay
:multi:delay?
Sets or returns trigger delay time for currently
selected step in millisecond.
Parameter: 0ms ~ 1000ms
Example: :multi:delay 10m (10ms)
:multi:freq
:multi:freq?
Sets or returns the frequency for the currently
selected step in Hz.
Parameter: 20 ~ 1/5/10MHz
Example: :multi:freq 1e3 (1kHz)
:multi:func
:multi:func?
Sets or returns measurement type for the currently
selected step.
Send parameter: LS, LP, Q, CS, CP, D, Z, PHASE,
RS, RP, X, G, B, Y, RDC
Return parameter: 1 (Z), 2 (Ls), 3 (Lp), 4 (Cs), 5
(Cp), 7 (Y), 8 (G), 9 (P), 10 (Q), 11 (D), 12 (Rs), 13
(Rp), 14 (B), 15 (X), 16 (Rdc)
Example: :multi:func ls (Series inductance)
:multi:hi-lim
:multi:hi-lim?
Sets or returns the higher test limit of the currently
selected step.
Example: :multi:hi-lim 10 (limit to 10.0)
:multi:lev
:multi:lev?
Sets or returns the drive level for the currently
selected step in Voltage.
Parameter: 10mV ~ 2V (DC/AC≤3 MHz)
10mV ~ 1V (AC>3 MHz)
Example: :multi:lev 200m (200mV)
:multi:load
Loads an existed file to run or edit.
Example: :multi:load demo (file name demo)
:multi:lo-lim
:multi:lo-lim?
Sets or returns the lower test limit of the currently
selected step.
Example: :multi:lo-lim –5 (limit to –5)