GW Instek LCR-8000G Series User Manual
Page 16
GETTING STARTED
31
31
31
31
8. Enter Run
menu
Press F6 (Run). The Run menu opens.
Page80
9. Set Single or
Repetitive
Press the Sing/Rep key to select Single
(manual trigger) or Repetitive (auto
trigger).
Page80
10. Start running If the test has not started yet, press F1
(Start) or Trig key. Press F6 (Set) to go
back to the setup menu.
Page80
File operation:
new program
Press F5 (File), then F4 (New). Press the
Left/Right keys to move the cursor and
press the Down key to select character. To
confirm the file name, press the Enter key.
A new file appears.
To delete a character, press the Up key.
To quit, press the Clear key.
Page74
File operation:
load
Press F5 (File), then F1 (Load). Use the
arrow keys to select the program and
press F1 (Load).
Page85
File operation:
delete
Press F5 (File), then F2 (Delete). Use the
arrow keys to select the program and
press F5 (Del).
Page86
File operation:
save as
Press F5 (File), then F3 (Save as). Press the
Left/Right keys to move the cursor and
press the Down key to select character. To
confirm the file name, press the Enter key.
A new file appears.
To delete a character, press the Up key.
To quit, press the Clear key.
Page83
LCR-8000G Series User Manual
32
32
32
32
Graph mode
Step
Description
Details
1. Connect fixture Connect the fixture to the DUT.
Page24
2. Enter graph
mode
Press the Menu key, then F4 (Graph).
Page88
3. Select item
Press F5 repeatedly to select the graph
item.
Page89
4a. Set horizontal
scale (frequency)
Press the Up/Down key to move the
cursor to Sweep. Press the Left/Right key
to select Frequency. Then move the cursor
to Start Frequency, set the value using the
numerical and unit keys. Repeat this for
Stop Frequency and Level (drive
Voltage).
Page92
4b. Set horizontal
scale (voltage)
Press the Up/Down key to move the
cursor to Sweep. Press the Left/Right key
to select Voltage. Then move the cursor to
Start Voltage, set the value using the
numerical and unit keys. Repeat this for
Stop Voltage and Freq (frequency).
Page90
5. Select speed
Press the Up/Down key to move the
cursor to Speed. Press the Left/Right key
to select the measurement speed.
Page101
6. Select step size Press the Up/Down key to move the
cursor to Step size. Press the Left/Right
key to select the data step (all or
sampled).
Page102
7. Select linear or
log scale
Press F1 (Lin/Log) to select linear or
logarithmic horizontal scale.
Page91
8a. Set vertical
scale (Absolute +
Auto fit)
Press F2 (Abs/%) to select Abs, then press
F3 (Manual/Auto fit) to select Auto fit.
the LCR-8000G automatically configures
the vertical scale.
Page98