GW Instek LCR-8000G Series User Manual
Page 4
SAFETY INSTRUCTION
7
77
7
Fuse
WARNING
•
Fuse type: T3A/250V
•
Make sure the correct type of fuse is installed
before power up.
•
To ensure fire protection, replace the fuse only
with the specified type and rating.
•
Disconnect the power cord before fuse
replacement.
•
Make sure the cause of fuse blowout is fixed
before fuse replacement.
Cleaning the LCR-
8000G
•
Disconnect the power cord before cleaning.
•
Use a soft cloth dampened in a solution of mild
detergent and water. Do not spray any liquid.
•
Do not use chemicals or cleaners containing
harsh materials such as benzene, toluene,
xylene, and acetone.
Operation
Environment
•
Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (Note below)
•
Relative Humidity: < 80%
•
Altitude: < 2000m
•
Temperature: 0°C to 40°C
LCR-8000G Series User Manual
8
88
8
(Pollution Degree) EN 61010-1:2001 specifies the pollution degrees
and their requirements as follows. The LCR-8000G falls under
degree 2.
Pollution refers to “addition of foreign matter, solid, liquid, or
gaseous (ionized gases), that may produce a reduction of dielectric
strength or surface resistivity”.
•
Pollution degree 1: No pollution or only dry, non-conductive
pollution occurs. The pollution has no influence.
•
Pollution degree 2: Normally only non-conductive pollution
occurs. Occasionally, however, a temporary conductivity caused
by condensation must be expected.
•
Pollution degree 3: Conductive pollution occurs, or dry, non-
conductive pollution occurs which becomes conductive due to
condensation which is expected. In such conditions, equipment
is normally protected against exposure to direct sunlight,
precipitation, and full wind pressure, but neither temperature
nor humidity is controlled.
Storage
environment
•
Location: Indoor
•
Relative Humidity: < 80%
•
Temperature: −40°C to 70°C
Disposal
Do not dispose this instrument as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased. Please make sure
discarded electrical waste is properly recycled to
reduce environmental impact.