GW Instek LCR-8000G Series - Manual (Page 39)

PASS-FAIL MODE
77 77 77 77
Set frequency Move the cursor to Freq column.
Enter the frequency using the
numerical keys and unit keys. Func
Freq
500.00
Ls
2.00 V Volt
Range 20Hz ~ 1MHz/5MHz/10MHz
5 digit resolution
Example:
0.5kHz (500Hz)
k Enter
Set voltage Move the cursor to Volt column.
Enter the voltage using the
numerical keys and unit keys. Freq
Volt
2.00 V
500.00
Bias
Range
(1mV step)
10mV ~ 2V (DC or AC≤3 MHz)
10mV ~ 1V (AC>3 MHz)
Example:
100mV
m V/A Enter
Select data
capture rate Move the cursor to Spd column.
Select the capture rate by
pressing F1 (Prog) repeatedly. Bias
Spd
MAX
1.0000H Hi
F 1
DC
AC≤
100Hz AC≤
2kHz AC>
2kHz AC≥
1MHz
Slow 900ms 1.3s 600ms 600ms 620ms
Med 120ms 1.2s 470ms 450ms 470ms
Fast 60ms 650ms 180ms 150ms 150ms
Max 30ms 600ms 120ms 75ms 120ms
LCR-8000G Series User Manual
78 78 78 78
Set Hi limit Move the cursor to Hi column.
Enter the Hi limit using the
numerical keys and unit keys. Spd
Hi
1.0000H
0.0000H Lo
MAX
Range follows the specification for each
measurement item
Example: 1.5kH
(for Ls)
Enter H k
Set Lo limit Move the cursor to Lo column.
Enter the Lo limit using the
numerical keys and unit keys. Spd
Hi
0.0000H Lo
MAX
1.0000H
Range follows the specification for each
measurement item
Example: 1.0kH
(for Ls)
Enter H k
Set trigger delay Move the cursor to Dly (Delay)
column. Enter the amount of
trigger delay time using the
numerical keys and unit keys.
Hi
Lo
10 ms Dly
1.0000H
0.0000H
Range 0 (no delay) ~ 1000ms
Example: 10ms
m