LumaSense Technologies LumaSoft Gas Multi Point 7860 - Manual (Page 18)

Chapter 2
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 18 of 194
7. Now you can change the IP port number by using the ▲ and ▼ keys.
The port number can be set in the range from 0 to 32767.
In case you want to return to the start value of the IP port number
press the CANCEL key. In case you want to return to the default
stored value of the IP port number press the DEFAULT key.
When you have set the IP port number, press the
↵ key. The screen
display now shows the following text.
8. In case you want the 1412i/1314i/3434i gas monitor to be able to
communicate only with a certain PC on the local network, you can
set the IP address of this PC as the protected IP address. This can be
desired due to security reasons so no other PC is able to
communicate with the 1412i/1314i/3434i gas monitor.
If no protection is desired the protected IP address should be set to
a value of 000.000.000.000.
If you want to change the protected IP address, press the
↵ key. If
the protected IP address does not need to be changed, press the ▼
key and you will proceed to the below step 10.
If you selected to change the protected IP address the screen display
now shows the following text.
9. Here you can change the 4 individual numbers in the protected IP
address by using the ▲ and ▼ keys. Each of the 4 individual
numbers can be set in the range from 000 to 255.
You can step between the 4 individual numbers in the protected IP
address by using the ◄ and ► keys.
In case you want to return to the start value of the protected IP
address press the CANCEL key. In case you want to return to the
default stored value of the protected IP address press the DEFAULT
key.
When you have set the protected IP address, press the
↵ key.
If you previously selected the IP address NOT to be set by the DHCP
server, you can proceed to the below step 11.
If you instead selected that the IP address to be set by the DHCP
server, the screen display now shows the following text.
1412i'S IP PORT NUMBER: 23
CANCEL DEFAULT
PROTECTED IP ADDRESS 000.000.000.000
PRESS ENTER TO CHANGE VALUE
PROTECTED IP ADDRESS 000.000.000.000
CANCEL DEFAULT