Yokogawa PC-Based MX100 - Manual (Page 92)

3-11
IM MX180-01E
Vewer
3
2
1
4
5
App
Index
• Mult-axes zone
All the specified Y-axis of the displayed waveforms are aligned horizontally. To hide
a Y-axis, clear the Y-axes check box on the General Display Settings window. The
display position is set using Zone on the General Display Settings window. Dragging
the channel bar to the waveform display area shows the Y-axis of the corresponding
channel. Dragging the Y-axis to the zone display area hides the Y-axis of the
corresponding channel.
Turn OFF the Y-axis
display of Ch00002
The Y-axis of Ch00002 is not displayed.
Select multi-axes zone
Click the bar to move the specified Y-axis to the right end
Indicates the
specified Y-axis
Grd Dsplay
Select the grid type.
When this is selected When this is selected When this is selected
Trp Pont
You can display a trip line to indicate a particular value of interest (trip point) in the
waveform display area. Two trip points (trip 1 is red, trip 2 is blue) can be set on each
waveform using the Trip 1 and Trip 2 settings on the General Display Settings window.
The trip line of the waveform corresponding to the right-most Y-axis bar is shown in the
waveform display area.
Turn ON the trip line display
Trip 1 value*
Trip 2 value*
Trip line
Trip 1 value
Trip 2 value
* Can be moved
by dragging
3.2 Dsplay Settngs