Yokogawa PC-Based MX100 - Manual (Page 13)

1-7
IM MX180-01E
Before Us
ng the Software
3
2
1
4
5
App
Index
Explanaton
Installaton Result
When the software program is installed properly, the folder MX100 Standard Software
is created in the specified directory (C:\ by default). MX100 Standard is registered in the
program list and MX100 Standard (referred to as the Integration Monitor in this operation
guide), MX100 Viewer, and MX100 Calibrator are registered under it.
Note
• The Data, Work, and Conv folders are created within the MX100 Standard folder. Recording
files are saved in the Data folder. The Work folder is used as a temporary folder for saving
files created by the MX100 Standard Software, and must not be deleted.
• The Conv folder is created by the Historical Viewer. It is used as a temporary folder for
storing files used for file conversion, and must not be deleted.
1.3 Setup Procedures of the MX100 Standard Software