Yokogawa PC-Based MX100 - Manual (Page 20)

2-6 IM MX180-01E
Dsconnectng the MX100
1. Click Connection to show the Connection screen.
2. Click the Disconnect button to the right of the IP Address or Host Name text box.
When the connection is dropped, a message “Currently no MXs are connected”
appears at the top section of the screen. To reconnect, click Connect.
Creatng a New Project and Connectng
Creatng a New Project
Carry out the procedure below to discard current settings and create new setup data
(project).
1. From the File menu, click New.
A dialog box with the message “Cancel the current settings and create a new project?”
appears. To save the current setup data before creating a new project, click No and save
the setup data (project) (see “Saving Setup Data (Project)” in section 2.12).
2. Click Yes.
The Connection screen opens. If you click New while the MX100 is connected,
communication with the connected MX100 is disconnected.
Connectng after Creatng a New Project
3. On the Connection screen, connect to the MX100.
(See “Connecting to an MX100 That Has Not Been Configured for the Network,” or
“Connecting to an MX100 That Has Been Configured for the Network,” in this section.)
2.1 Connectng and Dsconnectng the MX100