Yokogawa PC-Based MX100 - Manual (Page 113)

4-2 IM MX180-01E
When the connection is established, information about the unit’s module
configuration is displayed.
To disconnect the connected MX100
To illuminate the 7-segment LED of the
connected MX100 to see which MX100 is
connected Information about the connected MX100
Modules attached to the
connected MX100
If the specified IP address or host name is not correct, or the MX100 is connected
by another software program, the following dialog box opens.
Note
• You cannot change the MX100 network settings using the Calibrator. Use the Integration
Monitor (MX100 Standard Software) to change the IP address and other settings.
• If you change the module configuration before connecting with the Calibrator or if modules
that are not operating properly exist, X marks are displayed on the modules as shown
below.If you change the module configuration, use the Integration Monitor to reconfigure the
system.
• When using Windows XP, Windows Vista, or Windows 7 with the firewall enabled,
recognition is sometimes not successful even when clicking the Search button. To solve the
problem, see appendix 1. (The same problem may also occur if your anti-virus software is
using a firewall.)
4.1 Connectng the MX100