Yokogawa PC-Based MX100 - Manual (Page 60)

2-46 IM MX180-01E
Maxmum and Mnmum Values of the Y-Axs and the Dsplay Format of the
Scale Values
Specify the maximum and minimum values of the Y-axis scale. The scale values can also
be displayed using logarithmic format as shown below.
Select the exponential format
Selectng the Dsplay Zone of the Waveform
You can select from the following. In the Zone setting on the Display setup screen,
assume the bottom and top edges of the waveform display area to be 0% and 100%,
respectively, and set the waveform display position by specifying the minimum value (0
to 99%) and the maximum value (1 to 100%).
• User zone
Displays each waveform at the position specified by Zone on the Display setup
screen. A single Y-axis scale of the active waveform can be displayed.
Select user zone
Click the bar to select the active Y-axis scale
Displays the active Y-axis scale
Indicates the active Y-axis
Set the display zone
• Edt zone
Like the user zone, each waveform is displayed at the position specified by Zone on
the Display setup screen. However, you can change the zone on the Monitor screen.
A single Y-axis scale of the active waveform can be displayed.
Select edit zone
Drag the knob to change the minimum/maximum
value of the zone separately
Drag the bar to change the zone position without
changing the zone width
• Full zone
Displays all the waveforms over the full zone of the waveform display area regardless
of the Zone settings on the Display setup screen. A single Y-axis scale of the active
waveform can be displayed.
Select full zone
Waveform display area
(Full zone)
2.6 Dsplayng the Montor and Settng the Dsplay Procedure